VOLVO
PBM-U210054 - Control Module Not Configured. System Programming Failures. Missing calibration
System
Antriebsstrang (Motor & Getriebe)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
9 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
Was bedeutet der Fehlercode?
The electronic parking brake module (PBM) has a built-in inclination sensor used to decide how hard to apply the brake on a slope. The code means the inclination sensor has not been calibrated, the installation check has not been done, or the module is still in service mode.
Mögliche Ursachen
- The inclination sensor has not been calibrated, for example after replacing the module
- The installation check has not been carried out after fitting
- Service mode is still active, for example after replacing the rear brake pads
Was Sie tun können
- 1Find out whether the rear brakes or the parking brake module have recently been serviced or replaced
- 2Have a workshop with diagnostic equipment exit service mode, calibrate the inclination sensor and run the installation check
- 3Afterwards, check that the parking brake applies and releases correctly
- 4Do not rely on the parking brake on a slope until the fault is fixed – leave the car in gear or in P
Symptome, die Sie bemerken können3
- Parking brake warning lamp on
- Yellow warning symbol and message in the display
- The parking brake has reduced function
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.