VOLVO
PSCM-C102300 - Pull Drift Compensation Limit Exceeded. General Failure Information. No sub type information
System
Servolenkungs-Steuermodul (PSCM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
2 ModelleV40 (2013–), V40 Cross Country (2013–)
Modelle nach Baujahr und Motor anzeigen (2)
Was bedeutet der Fehlercode?
The compensation for oversteer or understeer has gone outside its tolerance. The control module uses built-in sensing to detect whether a wheel is spinning or the car is turning sharply, and then picks a response such as braking one wheel. The cause may lie in the tyres or the suspension.
Mögliche Ursachen
- Puncture in one or more tyres
- Unevenly worn tyres, compared front and rear
- Tyre with incorrect dimension fitted to the front or rear axle, compared with the other tyres on the car
- Incorrectly adjusted suspension
Was Sie tun können
- 1Check that no tyre is punctured and that the pressure is the same in all tyres
- 2Compare the tyre size and wear front and rear with each other and with the other tyres on the car
- 3Check that the tyres on the same axle are of the same size
- 4Clear the fault code and test drive to see whether it returns
- 5If the fault returns after the tyre check: have a workshop check the suspension alignment
- 6Safety note: steering and tyres are safety-critical, so have a workshop carry out the check if the car still pulls
Symptome, die Sie bemerken können2
- Steering requires extra or uneven effort
- Steering has excessive free play or wanders
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.