VOLVO
PSCM-U000100 - High Speed CAN Communication Bus. General Failure Information. No sub type information
System
Servolenkungs-Steuermodul (PSCM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
7 ModelleS60 (2011–), S80 (2007–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (11)
- Volvo S60 (2011–)2011–2013
- Volvo S60 (2011–)2014–2015Alle Motoren außer: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9, D4204T5
- Volvo S80 (2007–)2010Nur Motor: D4164T
- Volvo S80 (2007–)2011–2015
- Volvo V60 (2011–)2011–2013
- Volvo V60 (2011–)2014–2015Alle Motoren außer: B4204T11, B4204T12, B4204T15, B4204T9, D4204T5
- Volvo V60 Cross Country (2015–)2015
- Volvo V70 (2008–)2010Nur Motor: D4164T
- Volvo V70 (2008–)2011–2015
- Volvo XC60 (2009–)2011–2015
- Volvo XC70 (2008–)2011–2015
Was bedeutet der Fehlercode?
Communication on the HS-CAN bus has been interrupted, either by another control module on the bus or by the control module's own messages interfering with the network. The power steering control module then cannot be reached, and the power steering regulation does not work.
Mögliche Ursachen
- Short circuit between the CAN wiring
- Open circuit in the CAN wiring
- Internal fault in another control module on the same part of the CAN network
- Internal fault in the control module
Was Sie tun können
- 1Check that the battery is charged and that the fuses for the power steering are intact
- 2If you have a diagnostic tool: read off the fault codes in the other control modules and start with those
- 3Gently shake the wiring and connectors at the power steering while checking, to see whether the fault shows up
- 4Safety note: steering is safety-critical, so have a workshop with diagnostic equipment measure the CAN network
Symptome, die Sie bemerken können1
- The power steering regulation does not work
Was der Fehler beeinflussen kann3
- The control module shuts itself off ("bus-off")
- It remains shut off until its power is interrupted
- When the power supply is reconnected, the control module tries to communicate again
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.