VOLVO
SAS-0001 - LED group 1 circuit. Signal too low
System
Lenkwinkelsensor (SAS)
Volvo-Modelle, für die dieser Fehlercode gilt
Dieser Fehlercode hat je nach Modell, Modelljahr oder Motor unterschiedliche Bedeutungen. Wählen Sie die Bedeutung, die für Ihr Fahrzeug gilt.
Gilt für folgende Modelle:
5 ModelleS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (5)
Was bedeutet der Fehlercode?
The steering wheel angle sensor measures the wheel angle with LEDs and receivers that read code wheels, and the control unit monitors the current in LED group 1. The code is set when the current is too low, and then anti-spin and the stability function are blocked.
Mögliche Ursachen
- Poor contact or oxidation at the connections and connector blocks
- Short-circuit to ground in the LED circuit
- LED 1-4 defective; this applies to this code
- LED 5-8 defective; SAS-0025 is set instead
- Defective control unit
Was Sie tun können
- 1With the ignition off, check that the connectors at the angle sensor and the SWM are fully seated and free from oxidation
- 2With diagnostic equipment and the ignition on, read the current in the LED circuit
- 3With a multimeter, check that the cable from the steering wheel angle sensor has no contact with ground (the bodywork)
- 4If the connectors and cables are good, the steering wheel angle sensor may be defective; replacing it is a job for a workshop
- 5Safety: anti-spin and stability are switched off while the fault is present, so have a workshop remedy it; do not work on the steering wheel, steering wheel module or angle sensor yourself
Symptome, die Sie bemerken können3
- The anti-spin warning lamp is on
- The stability function does not work
- Anti-spin does not work
Was der Fehler beeinflussen kann2
- The AYC function is blocked
- The anti-spin function is blocked
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.