VOLVO
SAS-000C - Control module. Internal fault
System
Lenkwinkelsensor (SAS)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
5 ModelleS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (11)
- Volvo S60 (2001–2009)2005–2009
- Volvo S80 (1999–2006)2005–2006
- Volvo V70 (2000–2008)2005–2008
- Volvo V70 XC / XC70 (2001–2007)2005–2007
- Volvo XC90 (2003–)2005–2006Alle Motoren außer: B8444S
- Volvo XC90 (2003–)2007Nur Motor: B5254T2, D5244T4
- Volvo XC90 (2003–)2008–2010Alle Motoren außer: B6324S, B8444S
- Volvo XC90 (2003–)2011Alle Motoren außer: B6324S5, B8444S
- Volvo XC90 (2003–)2012Alle Motoren außer: B6324S5
- Volvo XC90 (2003–)2013–2014Nur Motor: B5254T9
- Volvo XC90 (2003–)2015
Was bedeutet der Fehlercode?
The steering wheel angle sensor control module has registered an internal fault. The stability control function is blocked while the fault is present. The module is mounted in the lever module, shared with the steering wheel module, and is powered from there.
Mögliche Ursachen
- Fault inside the SAS control module itself
Was Sie tun können
- 1Read and note the code, clear it and road test to see whether it returns
- 2Turn the steering wheel fully to the right, then fully to the left, set it straight ahead and read the code again
- 3With diagnostic equipment, compare the counters for the fault status: many incorrect driving cycles point to a recurring fault
- 4If the code returns, have a workshop replace the steering wheel module (SWM)
- 5The stability function stays blocked while the fault is present, so have a workshop repair it promptly
Symptome, die Sie bemerken können3
- Anti-spin warning lamp is on
- General warning lamp is on
- Stability control function not working
Was der Fehler beeinflussen kann1
- Stability function blocked
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.