Was bedeutet der Fehlercode SAS-0013?

Diagnose und Fehlercodedefinition für SAS-0013 (Volvo S60 (2001–2009), Volvo S80 (1999–2006), Volvo V70 (2000–2008)). Steuergerätereparatur bei OBD Tuning.

VOLVO

SAS-0013 - Steering wheel position signal R2. Signal too high. Intermittent fault

System

Lenkwinkelsensor (SAS)

Volvo-Modelle, für die dieser Fehlercode gilt

Gilt für folgende Modelle:

5 Modelle

S60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)

Modelle nach Baujahr und Motor anzeigen (5)

Was bedeutet der Fehlercode?

Steering wheel position signal R2 reads too high. The fault is intermittent and may have occurred earlier without being active now. Possible causes are poor contact, a short to supply voltage, an open circuit in the wiring, or a defective control module.

Mögliche Ursachen

Contact resistance or oxidation in connections and connectors
Short circuit to voltage supply
Open circuit in the wiring
Defective control module

Was Sie tun können

1Read and note the code, clear it and road test to see whether it returns
2Check that the connector at the steering wheel angle sensor is firmly seated, clean and free from corrosion
3Inspect the wiring between the sensor and the control module for chafing and loose clips, especially where the cable moves
4With diagnostic equipment, follow the R2 signal in live data while turning the wheel slowly and check that the value follows the wheel smoothly
5Stability control is off while the fault is present, so have a workshop repair it promptly if it returns

Symptome, die Sie bemerken können3

Anti-spin warning lamp on
Stabilising function absent
Anti-spin not working

Was der Fehler beeinflussen kann2

Stability function disconnected
Anti-spin function blocked

Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.