VOLVO
SAS-0024 - Steering wheel angle sensor. No signal. Intermittent fault
System
Lenkwinkelsensor (SAS)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
5 ModelleS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (5)
Was bedeutet der Fehlercode?
The control module gets no reading from the angle sensor, and the fault is intermittent: it has occurred at some point but may not be active right now. Causes include a disconnected connector, a break in the feed or signal wires, or an internal fault in the control module.
Mögliche Ursachen
- Sensor connector not fully plugged in
- Break in the feed voltage to the sensor
- Open circuit in the signal wires
- Internal fault in the sensor control module
Was Sie tun können
- 1Read and note the code, clear it and road test to see whether it returns
- 2Check that the connector at the steering wheel angle sensor is fully plugged in
- 3Check the connectors in the wiring between the control module and the sensor for oxide and contact resistance
- 4Look for breaks in the wiring between the control module and the sensor, especially where there is chafing or pinching
- 5Stability control is off while the fault is present, so have a workshop repair it promptly if it returns
Symptome, die Sie bemerken können3
- Anti-spin warning lamp on
- Stabilising function absent
- Anti-spin not working
Was der Fehler beeinflussen kann2
- Stability control disconnected
- Anti-spin function blocked
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.