VOLVO
SAS-0044 - Steering wheel angle sensor Signal faulty
System
Lenkwinkelsensor (SAS)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
5 ModelleS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (5)
Was bedeutet der Fehlercode?
The sensor's control module has registered that the voltage on angle signal A or B is either too low or too high. The cause is a fault inside the control module itself.
Mögliche Ursachen
- Fault inside the sensor control module
Was Sie tun können
- 1Read and note the code, clear it and road test to see whether it returns
- 2Check that the connectors at the sensor control module and the steering wheel module are firmly seated and free from oxide
- 3If the fault disappears once the connectors have been cleaned and reseated, poor contact or oxide was probably the cause
- 4With a multimeter, check that the wiring between the control module and the sensor is not short-circuited to ground or to supply voltage
- 5Stability control is off while the fault is present, so have a workshop repair it promptly
Symptome, die Sie bemerken können3
- Anti-spin warning lamp on
- Stability control not working
- Anti-spin not working
Was der Fehler beeinflussen kann2
- Stability function disconnected
- Anti-spin function blocked
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.