VOLVO
SAS-C1B0041 - Steering angle sensor. System Internal Failures. General checksum failure
System
Lenkwinkelsensor (SAS)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
4 ModelleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Modelle nach Baujahr und Motor anzeigen (8)
- Volvo C30 (2007–2013)2011Nur Motor: D4162T, D4164T, D5204T, D5204T5
- Volvo C30 (2007–2013)2012–2013Nur Motor: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Nur Motor: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Alle Motoren außer: B5254T7
- Volvo S40 (2004–2013)2011Nur Motor: D4162T, D4164T, D5204T, D5204T5
- Volvo S40 (2004–2013)2012Nur Motor: D4162T, D5204T, D5204T5
- Volvo V50 (2004–2013)2011Nur Motor: D4162T, D4164T, D5204T, D5204T5
- Volvo V50 (2004–2013)2012Nur Motor: D4162T, D5204T, D5204T5
Was bedeutet der Fehlercode?
The steering angle sensor (SAS) sends its information to the other control modules over the CAN network, and the information carries a checksum. The code means the checksum does not match, which is caused by an internal fault in the steering angle sensor.
Mögliche Ursachen
- Internal malfunction within the steering angle sensor (SAS).
Was Sie tun können
- 1Switch off the ignition, wait a while and start the engine. Check whether the code is still stored, clear it and test drive the car.
- 2If the fault is permanent, have a workshop replace the steering angle sensor (SAS).
- 3Check that the battery is charged and that the fuses are intact, since voltage problems can cause faults in communication between the control modules.
- 4The steering angle sensor is connected to the stability system. Have a workshop diagnose and replace it rather than working on the steering wheel yourself.
Symptome, die Sie bemerken können2
- The traction control warning lamp lights up
- The stability control system does not work
Was der Fehler beeinflussen kann1
- Active yaw control (AYC) is blocked
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.