VOLVO
SAS-E000 - Control module communication. Faulty communication
System
Lenkwinkelsensor (SAS)
Volvo-Modelle, für die dieser Fehlercode gilt
Dieser Fehlercode hat je nach Modell, Modelljahr oder Motor unterschiedliche Bedeutungen. Wählen Sie die Bedeutung, die für Ihr Fahrzeug gilt.
Gilt für folgende Modelle:
5 ModelleS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (5)
Was bedeutet der Fehlercode?
The steering angle sensor (SAS) sends and receives information over the CAN network. The code is set when serious interference blocks CAN communication. The control module then shuts itself off from the network and stays off until the power has been cut.
Mögliche Ursachen
- Short circuit between the CAN wires.
- Open circuit in one of the CAN wires.
- Internal fault in the steering angle sensor (SAS).
- Internal fault in another control module on the same part of the CAN network.
Was Sie tun können
- 1Check that the battery terminals and cables are tight and clean.
- 2If the anti-spin warning lamp stays lit after the battery check, have a workshop read the fault codes and measure the CAN wiring.
- 3Have a workshop check the CAN wiring for short circuits and open circuits, and replace the wiring if needed.
- 4The angle sensor is connected to the stability system. Have a workshop carry out the fault tracing and repair rather than working in the steering system yourself.
Symptome, die Sie bemerken können2
- The anti-spin warning lamp lights up
- The stability function does not work
Was der Fehler beeinflussen kann2
- The sensor shuts itself off from the CAN network (bus-off)
- It tries to communicate again when the power is switched on
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.