VOLVO
SAS-E003 - Configuration fault Faulty configuration
System
Lenkwinkelsensor (SAS)
Volvo-Modelle, für die dieser Fehlercode gilt
Dieser Fehlercode hat je nach Modell, Modelljahr oder Motor unterschiedliche Bedeutungen. Wählen Sie die Bedeutung, die für Ihr Fahrzeug gilt.
Gilt für folgende Modelle:
5 ModelleS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (5)
Was bedeutet der Fehlercode?
The steering angle sensor checks its configuration ID against the signal setup that the central electronic module (CEM) transmits over CAN. The code is set when the two disagree, or when the link to the CEM is cut. Ordinary CAN traffic then stops, although the sensor still answers diagnostic requests.
Mögliche Ursachen
- Wrong CAN configuration ID because the unit is meant for another vehicle, such as a used unit with different software or hardware.
- Open circuit in the CAN cabling linking the unit to the central electronic module (CEM).
Was Sie tun können
- 1Check that the steering wheel module or angle sensor is intended for your car. A used part from another car can cause this code.
- 2Check that the connectors are firmly seated and not corroded, and have a workshop measure the wiring.
- 3If no other fault is found, a workshop can load new software into the angle sensor, but only after agreeing it with you.
- 4The angle sensor is part of the stability system. Have a workshop carry out the fault tracing and any software loading rather than working on the steering wheel yourself.
Symptome, die Sie bemerken können4
- The anti-spin warning lamp lights up on cars of model year 2002 and earlier
- The general warning lamp lights up on cars of model year 2003 and later
- The stability function does not work
- A message appears in the text display
Was der Fehler beeinflussen kann1
- The sensor cannot communicate normally on the CAN network
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.