VOLVO
TCM-040A - Shift fork 2. Plausible position
System
Getriebesteuergerät (TCM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
4 ModelleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Modelle nach Baujahr und Motor anzeigen (10)
- Volvo C30 (2007–2013)2008Nur Motor: D4204T · Nur Getriebe: MPS6
- Volvo C30 (2007–2013)2009–2010Nur Motor: B4204S3, D4204T · Nur Getriebe: MPS6
- Volvo C30 (2007–2013)2011–2013Nur Motor: B4204S3 · Nur Getriebe: MPS6
- Volvo C70 (2006–2013)2009–2010Nur Motor: D4204T · Nur Getriebe: MPS6
- Volvo S40 (2004–2013)2008Nur Motor: D4204T · Nur Getriebe: MPS6
- Volvo S40 (2004–2013)2009–2010Nur Motor: B4204S3, D4204T · Nur Getriebe: MPS6
- Volvo S40 (2004–2013)2011–2012Nur Motor: B4204S3 · Nur Getriebe: MPS6
- Volvo V50 (2004–2013)2008Nur Motor: D4204T · Nur Getriebe: MPS6
- Volvo V50 (2004–2013)2009–2010Nur Motor: B4204S3, D4204T · Nur Getriebe: MPS6
- Volvo V50 (2004–2013)2011–2012Nur Motor: B4204S3 · Nur Getriebe: MPS6
Was bedeutet der Fehlercode?
The transmission control module (TCM) has found that the position of shift fork 2 is unreasonable. Shift fork 2 is one of four forks that engage the gears mechanically using solenoids, and each fork reports its position to the control module through its own position sensor.
Mögliche Ursachen
- Damaged position sensor for shift fork 2
- The position sensor reports an incorrect position
- Incorrect voltage supply to the sensor
- Damaged transmission control module (TCM)
Was Sie tun können
- 1Read out the fault codes from the transmission control module and deal first with any codes that may share the same cause, since a fault in the gearbox often sets several codes
- 2If you have diagnostic equipment, compare the position value for shift fork 2 with the others in live data and see whether anything stands out clearly
- 3If readings are within limits, the fault has probably been sporadic; clear the code and road test to see whether it returns
- 4If a value is outside or at the limit, a workshop should replace the mechatronic unit
- 5If the fault is inside the control module, it must be replaced; a new module is delivered without software and must be programmed by a workshop
Symptome, die Sie bemerken können5
- Check engine light comes on or behaves abnormally
- Yellow warning symbol with a message in the display
- Gears shift hard or jerky, sometimes or all the time
- Gears shift too early, too late or too often, sometimes or all the time
- No movement forward or in reverse with a gear selected
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.