VOLVO
TCM-041C - Position sensor shift fork 4. Faulty position
System
Getriebesteuergerät (TCM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
4 ModelleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Modelle nach Baujahr und Motor anzeigen (10)
- Volvo C30 (2007–2013)2008Nur Motor: D4204T · Nur Getriebe: MPS6
- Volvo C30 (2007–2013)2009–2010Nur Motor: B4204S3, D4204T · Nur Getriebe: MPS6
- Volvo C30 (2007–2013)2011–2013Nur Motor: B4204S3 · Nur Getriebe: MPS6
- Volvo C70 (2006–2013)2009–2010Nur Motor: D4204T · Nur Getriebe: MPS6
- Volvo S40 (2004–2013)2008Nur Motor: D4204T · Nur Getriebe: MPS6
- Volvo S40 (2004–2013)2009–2010Nur Motor: B4204S3, D4204T · Nur Getriebe: MPS6
- Volvo S40 (2004–2013)2011–2012Nur Motor: B4204S3 · Nur Getriebe: MPS6
- Volvo V50 (2004–2013)2008Nur Motor: D4204T · Nur Getriebe: MPS6
- Volvo V50 (2004–2013)2009–2010Nur Motor: B4204S3, D4204T · Nur Getriebe: MPS6
- Volvo V50 (2004–2013)2011–2012Nur Motor: B4204S3 · Nur Getriebe: MPS6
Was bedeutet der Fehlercode?
The sensor for shift fork 4 indicates that the fork is out of its position, although the shaft speeds for the gear in use look normal. The transmission control module (TCM) has therefore found that the sensor's position and the fork's real position do not agree.
Mögliche Ursachen
- Damaged position sensor
- The sensor gives the control module an incorrect position
- Incorrect voltage supply to the sensor
- Damaged transmission control module (TCM)
Was Sie tun können
- 1Read out the fault codes from the transmission control module and deal first with any codes that may share the same cause
- 2Have a workshop with diagnostic equipment check the voltage supply to the position sensors; if it is outside the normal range, the fault is inside the control module
- 3If you have diagnostic equipment, compare the position value for shift fork 4 with the others in live data and see whether it stands out clearly
- 4If a value is outside or at the limit, a workshop should replace the mechatronic unit; if readings are within limits, the fault has probably been sporadic
- 5If the fault is inside the control module, it must be replaced, and a new module is delivered without software and must be programmed by a workshop
Symptome, die Sie bemerken können5
- Check engine light comes on or behaves abnormally
- Message and yellow warning symbol in the display
- Gears shift hard or jerky, sometimes or all the time
- Gear changes take too long to complete, sometimes or all the time
- No forward or reverse movement with a gear selected
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.