VOLVO
TCM-P070700 - Transmission Gear Position Sensor "A" Circuit Low. General Failure Information. No sub type information
System
Getriebesteuergerät (TCM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
9 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo S60 (2011–)2014–2015Nur Getriebe: TG-81SC
- Volvo S80 (2007–)2014–2015Nur Getriebe: TG-81SC
- Volvo V40 (2013–)2015Nur Getriebe: TG-81SC
- Volvo V40 Cross Country (2013–)2015Nur Getriebe: TG-81SC, TG-81SC AWD
- Volvo V60 (2011–)2014–2015Nur Getriebe: TG-81SC
- Volvo V60 Cross Country (2015–)2015Nur Getriebe: TG-81SC
- Volvo V70 (2008–)2014–2015Nur Getriebe: TG-81SC
- Volvo XC60 (2009–)2014–2015Nur Getriebe: TG-81SC
- Volvo XC70 (2008–)2014–2015Nur Getriebe: TG-81SC
Was bedeutet der Fehlercode?
The gear range sensor inside the transmission control module gives a signal that is too low. The sensor has two Hall sensors that detect the selector position, and a parallel Hall sensor is used for diagnosis. The fault may lie in the connector, a wire, the selector cable adjustment or the module itself.
Mögliche Ursachen
- Contact resistance, oxidation or looseness in the connectors or connections
- Signal wire shorted to ground
- Misadjusted gear range sensor
- Internal fault in the transmission control module
Was Sie tun können
- 1Check that the selector cable is correctly fitted and adjusted; have a workshop adjust it if needed
- 2With the ignition off, check the connector to the transmission control module for contact resistance, oxidation and looseness
- 3Use a multimeter to check that the signal wire is not shorted to ground
- 4Clear the fault code and road test the car to see whether it comes back
- 5Have a workshop replace the transmission control module if the fault remains; a new module must be programmed
Symptome, die Sie bemerken können3
- Yellow warning symbol and text message in the display
- The malfunction indicator (Check engine) lamp comes on or behaves abnormally
- The engine does not start
Was der Fehler beeinflussen kann2
- The engine will not start while the fault is active
- The control module switches to an emergency program
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.