TCM-P171986
VOLVO
TCM-P171986 - Engine Torque Signal. Bus Signal / Message Failures. Signal invalid
System
Getriebesteuergerät (TCM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
9 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo S60 (2011–)2014–2015Nur Getriebe: TG-81SC
- Volvo S80 (2007–)2014–2015Nur Getriebe: TG-81SC
- Volvo V40 (2013–)2015Nur Getriebe: TG-81SC
- Volvo V40 Cross Country (2013–)2015Nur Getriebe: TG-81SC, TG-81SC AWD
- Volvo V60 (2011–)2014–2015Nur Getriebe: TG-81SC
- Volvo V60 Cross Country (2015–)2015Nur Getriebe: TG-81SC
- Volvo V70 (2008–)2014–2015Nur Getriebe: TG-81SC
- Volvo XC60 (2009–)2014–2015Nur Getriebe: TG-81SC
- Volvo XC70 (2008–)2014–2015Nur Getriebe: TG-81SC
Was bedeutet der Fehlercode?
The fault code concerns the engine torque signal on HS-CAN 1, which the transmission control module uses for shift points and system pressure. The signal is missing or indicated as faulty. The fault is general and does not say more precisely what type of fault it is. The cause may lie in the engine control module or in the CEM.
Mögliche Ursachen
- Sporadic open or shorted CAN wire between the engine control module and the transmission control module
- Fault in the engine control module (ECM)
- Fault in the central electronic module (CEM)
Was Sie tun können
- 1Read the fault codes in the engine control module and the CEM, and fix those first
- 2This code can be cleared only after the root fault has been fixed and its fault code cleared
- 3Have a workshop check the CAN network between the engine control module and the transmission control module for open circuits and short-circuits
Symptome, die Sie bemerken können5
- Warning symbol and text message in the display, and the check engine light lit or behaving abnormally
- Engine stalls when a gear is engaged
- Engine stalls when slowing down
- Lockup does not work
- Gear changes harsh or jerky on both upshifts and downshifts
Was der Fehler beeinflussen kann3
- If the torque signal on HS-CAN 2 is also faulty, the control module uses a basic value for the signal
- Adaptation is blocked
- Slip lock-up and automatic engine start/stop are switched off
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.