TCM-P271500 - Pressure Control Solenoid "SL3" Stuck ON. General Failure Information. No sub type information
System
Getriebesteuergerät (TCM)
Volvo-Modelle, für die dieser Fehlercode gilt
Dieser Fehlercode hat je nach Modell, Modelljahr oder Motor unterschiedliche Bedeutungen. Wählen Sie die Bedeutung, die für Ihr Fahrzeug gilt.
Gilt für folgende Modelle:
9 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo S60 (2011–)2014–2015Nur Getriebe: TG-81SC
- Volvo S80 (2007–)2014–2015Nur Getriebe: TG-81SC
- Volvo V40 (2013–)2015Nur Getriebe: TG-81SC
- Volvo V40 Cross Country (2013–)2015Nur Getriebe: TG-81SC, TG-81SC AWD
- Volvo V60 (2011–)2014–2015Nur Getriebe: TG-81SC
- Volvo V60 Cross Country (2015–)2015Nur Getriebe: TG-81SC
- Volvo V70 (2008–)2014–2015Nur Getriebe: TG-81SC
- Volvo XC60 (2009–)2014–2015Nur Getriebe: TG-81SC
- Volvo XC70 (2008–)2014–2015Nur Getriebe: TG-81SC
Was bedeutet der Fehlercode?
The fault code concerns line pressure solenoid SL3, which controls the pressure to the clutches. The control module has detected that the gear ratio stays the same when clutch C3 should have released. The shift is then cancelled so that clutches and brakes are not damaged. The fault is general and does not say more precisely what type of fault it is.
Mögliche Ursachen
- Incorrect adaptation values stored in the gearbox control module
- Contact resistance, oxidation or a loose joint at the plug of line pressure solenoid SL3
- Line pressure solenoid SL3 has jammed or is damaged
- Clutch C3 is damaged
- Poor quality of the transmission fluid
- Internal fault in the transmission's control system or in the transmission control module (TCM), or a mechanical fault in the gearbox
Was Sie tun können
- 1Read the fault codes in the gearbox and fix any other fault codes first, as they may be the cause
- 2Have a workshop check the transmission oil level and quality, as poor oil can cause the code
- 3Have a workshop check solenoid SL3, its connector and clutch C3, and replace the mechatronic unit if needed
Symptome, die Sie bemerken können5
- Warning symbol and text message in the display
- Check engine light lit or behaving abnormally
- The car lacks power
- Engine stalls when a gear is engaged or when slowing down
- No automatic gear change, and no forward or reverse movement with a gear engaged
Was der Fehler beeinflussen kann3
- The control module blocks the gears that are not available
- Neutral control is blocked
- Automatic engine start/stop is switched off
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.