VOLVO
TCM-P280900 - Pressure Control Solenoid "SL5" Stuck ON. General Failure Information. No sub type information
System
Getriebesteuergerät (TCM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
9 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo S60 (2011–)2014–2015Nur Getriebe: TG-81SC
- Volvo S80 (2007–)2014–2015Nur Getriebe: TG-81SC
- Volvo V40 (2013–)2015Nur Getriebe: TG-81SC
- Volvo V40 Cross Country (2013–)2015Nur Getriebe: TG-81SC, TG-81SC AWD
- Volvo V60 (2011–)2014–2015Nur Getriebe: TG-81SC
- Volvo V60 Cross Country (2015–)2015Nur Getriebe: TG-81SC
- Volvo V70 (2008–)2014–2015Nur Getriebe: TG-81SC
- Volvo XC60 (2009–)2014–2015Nur Getriebe: TG-81SC
- Volvo XC70 (2008–)2014–2015Nur Getriebe: TG-81SC
Was bedeutet der Fehlercode?
The transmission control module (TCM) has detected that the gear ratio does not change when band brake B1 should have been disengaged. If a disengagement is not carried out correctly, the gear change is aborted so the clutches and brakes are not damaged. The fault may be caused by linear pressure solenoid SL5 sticking, but a damaged band brake or other parts of the transmission can also cause it.
Mögliche Ursachen
- Wrong adaptation values held in the TCM memory
- Contact resistance, oxidation or poor connection at the SL5 connector or joint
- SL5 is stuck or damaged
- Band brake is damaged
- Poor transmission fluid quality
- Mechanical fault in the transmission, or internal fault in the transmission control system or in the TCM
Was Sie tun können
- 1Read all transmission codes and deal with any other transmission codes first, as they may be the root cause
- 2Check the transmission oil level and the condition of the oil, and look for oil leaks
- 3Check that the battery is in good condition and that the fuses are intact
- 4If the fault returns, have a workshop reset the adaptation and check SL5 and the band brake, and replace the mechatronic unit if needed
Symptome, die Sie bemerken können5
- Message in the display
- The malfunction indicator lamp (check engine light) comes on
- Poor performance, the car lacks power
- The engine stalls when a gear is selected
- The engine can stall when slowing down
Was der Fehler beeinflussen kann3
- Gears that are not available are blocked
- Neutral control is blocked
- Automatic engine start and stop is switched off
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.