VOLVO
TCM-P281500 - Pressure Control Solenoid "SL5" Control Circuit High. General Failure Information. No sub type information
System
Getriebesteuergerät (TCM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
9 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo S60 (2011–)2014–2015Nur Getriebe: TG-81SC
- Volvo S80 (2007–)2014–2015Nur Getriebe: TG-81SC
- Volvo V40 (2013–)2015Nur Getriebe: TG-81SC
- Volvo V40 Cross Country (2013–)2015Nur Getriebe: TG-81SC, TG-81SC AWD
- Volvo V60 (2011–)2014–2015Nur Getriebe: TG-81SC
- Volvo V60 Cross Country (2015–)2015Nur Getriebe: TG-81SC
- Volvo V70 (2008–)2014–2015Nur Getriebe: TG-81SC
- Volvo XC60 (2009–)2014–2015Nur Getriebe: TG-81SC
- Volvo XC70 (2008–)2014–2015Nur Getriebe: TG-81SC
Was bedeutet der Fehlercode?
The transmission control module (TCM) has detected that the current in the circuit to linear pressure solenoid SL5 is higher than allowed. SL5 regulates the system pressure in the transmission, so the fault affects the gear changes. The cause may be a wire shorted to supply voltage, a damaged solenoid or an internal fault in the control module.
Mögliche Ursachen
- Contact resistance, oxidation or poor connection at the SL5 connector or joint
- Short to supply voltage in the wiring to SL5
- SL5 is stuck
- SL5 is damaged
- Internal fault in the transmission control system or in the TCM
Was Sie tun können
- 1Read and note the code, clear it and road test the car to see whether it returns
- 2Check that the battery is in good condition and that the fuses are intact
- 3Check that the connectors at the transmission are fully engaged
- 4If the fault returns, have a workshop check SL5, the wiring and the control module, and replace the mechatronic unit if needed
Symptome, die Sie bemerken können5
- Message in the display
- The malfunction indicator lamp comes on or behaves abnormally
- Poor performance, the car lacks power
- No automatic gear changes
- No movement forward or in reverse with a gear selected
Was der Fehler beeinflussen kann3
- Gears that are not available are blocked
- Adaptation and neutral control are blocked
- Automatic engine start and stop is switched off
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.