VOLVO
TCM-P301500 - Torque Limit Delay - Signal Failure. General Failure Information. No sub type information
System
Getriebesteuergerät (TCM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
9 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo S60 (2011–)2014–2015Nur Getriebe: TG-81SC
- Volvo S80 (2007–)2014–2015Nur Getriebe: TG-81SC
- Volvo V40 (2013–)2015Nur Getriebe: TG-81SC
- Volvo V40 Cross Country (2013–)2015Nur Getriebe: TG-81SC, TG-81SC AWD
- Volvo V60 (2011–)2014–2015Nur Getriebe: TG-81SC
- Volvo V60 Cross Country (2015–)2015Nur Getriebe: TG-81SC
- Volvo V70 (2008–)2014–2015Nur Getriebe: TG-81SC
- Volvo XC60 (2009–)2014–2015Nur Getriebe: TG-81SC
- Volvo XC70 (2008–)2014–2015Nur Getriebe: TG-81SC
Was bedeutet der Fehlercode?
The transmission control module (TCM) receives no valid signal for the requested torque limit from the engine control module on HS-CAN 2. The signal helps decide shift points and adjusts the system pressure in the transmission. The control module then uses the matching signal on HS-CAN 1 instead.
Mögliche Ursachen
- The cause should be sought in the engine control module (ECM)
- Temporary breaks or a short on the CAN wire between the ECM and the TCM
Was Sie tun können
- 1Read the codes in the central electronics control module (CEM) and the engine control module first, and deal with them
- 2Do not clear this code until the fault in the engine control module is fixed and its code is cleared
- 3If no codes are stored, have a workshop troubleshoot the CAN network
Symptome, die Sie bemerken können1
- No noticeable symptoms for the driver
Was der Fehler beeinflussen kann2
- The control module uses the signal from HS-CAN 1 instead
- If that signal is also faulty, the control module uses a default value
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.