BCM-0108 - Communication between control modules. Communication with the steering angle sensor. Control module not initiated
System
Bremssteuergerät (BCM)
Volvo-Modelle, für die dieser Fehlercode gilt
Dieser Fehlercode hat je nach Modell, Modelljahr oder Motor unterschiedliche Bedeutungen. Wählen Sie die Bedeutung, die für Ihr Fahrzeug gilt.
Gilt für folgende Modelle:
5 ModelleS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (11)
- Volvo S60 (2001–2009)2002–2009
- Volvo S80 (1999–2006)2002–2006
- Volvo V70 (2000–2008)2002–2008
- Volvo V70 XC / XC70 (2001–2007)2002–2007
- Volvo XC90 (2003–)2003–2004, 2015
- Volvo XC90 (2003–)2005–2006Alle Motoren außer: B8444S
- Volvo XC90 (2003–)2007Nur Motor: B5254T2, D5244T4
- Volvo XC90 (2003–)2008–2010Alle Motoren außer: B6324S, B8444S
- Volvo XC90 (2003–)2011Alle Motoren außer: B6324S5, B8444S
- Volvo XC90 (2003–)2012Alle Motoren außer: B6324S5
- Volvo XC90 (2003–)2013–2014Nur Motor: B5254T9
Was bedeutet der Fehlercode?
The steering angle sensor module (SAS) is initialised when the steering wheel is turned to either side after the car is started. If the brake control module finds that SAS has not been initialised in time, and the car has also been driven for a while, the code is set. This can happen if the driver has driven straight ahead for a long time and switched off the ignition before initialisation.
Mögliche Ursachen
- The driver drove straight ahead for a long time after starting and then switched off the ignition, so SAS was not initialised
- Internal fault in the steering angle sensor (SAS)
Was Sie tun können
- 1Check whether the car was recently driven straight ahead for a long time without the steering wheel being turned, and turn the wheel to either side after starting to initialise SAS
- 2Clear the code and check whether it returns
- 3If the fault remains, have a workshop read the codes in SAS with diagnostic equipment
- 4The brake system is safety critical: do not replace the brake control module for this code, and drive carefully until the fault is fixed
Symptome, die Sie bemerken können3
- Anti-spin warning lamp on
- General yellow warning lamp on
- Anti-skid does not work
Was der Fehler beeinflussen kann1
- Active yaw control (AYC) is disabled
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.