VOLVO
ABS-00A6 - Brake pressure sensor 1 & 2. Signal outside its permitted range
Układ
Układ hamulcowy (ABS)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
4 modeleS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007)
Pokaż modele wg rocznika i silnika (4)
Co oznacza ten kod błędu?
Brake pressure sensors 1 and 2 give the ABS control module information about the brake system pressure. The module has registered that the signal from one of the sensors is implausible, which can come from a wiring fault, an incorrectly fitted sensor or a faulty sensor. This code applies only to cars with stability control, and anti-spin and stability are blocked for as long as the fault remains.
Możliwe przyczyny
- Open circuit in the wiring
- Wiring shorted to ground or supply voltage
- Sensor incorrectly installed
- Faulty pressure sensor or defective control module
Co możesz zrobić
- 1Check the connectors at the ABS module and at the brake pressure sensors for contact resistance and oxidation
- 2Check the wiring to both sensors for breaks and shorts to ground or supply voltage
- 3Check that the sensors are correctly installed
- 4Have a workshop read the brake pressure while the pedal is pressed; if the reading rises as it should, the fault was most likely a poor contact
- 5If the fault remains, have a workshop with diagnostic equipment check both sensors
- 6ABS and stability control are safety-critical – do not work on the brake system yourself, have a workshop do it
Objawy, które możesz zauważyć3
- Anti-spin does not function
- Stability function is absent
- Anti-spin warning lamp lit
Na co może wpływać usterka2
- Anti-spin function is blocked
- Stability function is blocked
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.