VOLVO
ABS-00B4 - Communication control unit SAS control unit not initiated
Układ
Układ hamulcowy (ABS)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
4 modeleS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007)
Pokaż modele wg rocznika i silnika (4)
Co oznacza ten kod błędu?
The steering angle sensor module (SAS) is initialised when the steering wheel is turned in either direction shortly after the car is started. If this does not happen, no steering angle is sent to the ABS module. This code applies only to cars with stability control, and while it is present anti-spin and stability are blocked. The cause is either a fault on the CAN data network or an internal fault in the SAS control unit.
Możliwe przyczyny
- Disturbances on the CAN network
- Internal fault in the steering angle sensor module (SAS)
Co możesz zrobić
- 1Turn the steering wheel in either direction after starting and check whether the fault clears
- 2Read the codes in the steering angle sensor control unit and trace them according to the system information
- 3Check the battery and its terminals, since voltage problems can disturb the CAN network
- 4If the fault remains, have a workshop with diagnostic equipment check the network and the control unit
- 5ABS, stability and steering are safety-critical – do not work on the ABS module or the steering angle sensor yourself, have a workshop do it
Objawy, które możesz zauważyć3
- Anti-spin does not work
- Stability function is absent
- Anti-spin warning lamp lit
Na co może wpływać usterka2
- Anti-spin function is blocked
- Stability function is blocked
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.