VOLVO
ADM-U014000 - Lost communication with Central Electronic Module (CEM). General Failure Information. No sub type information
Układ
Moduł dozowania dodatku do paliwa (ADM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
2 modeleS80 (2007–), V70 (2008–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The additive dosing module (ADM) has lost contact with the central electronic module (CEM). This is a general fault code that does not say which type of fault it is. It can only be read out if the fault is intermittent, because the module cannot communicate while the fault is active. The fault may lie in the data network or in the CEM.
Możliwe przyczyny
- Short circuit between the CAN wires
- Open circuit in one of the CAN wires
- Internal fault in the control module
- Internal fault in another control module on the same part of the CAN network
Co możesz zrobić
- 1Read the codes in the central electronic module (CEM) first, since the CEM monitors the voltage on the CAN wires
- 2Check the battery and its terminals so the voltage is stable
- 3With diagnostic equipment check the data network and the connectors between the modules
- 4Do not replace the CEM for a CAN fault unless fault-finding shows an internal fault
- 5Clear the code once the cause is fixed and check that it does not return
Objawy, które możesz zauważyć1
- No clear symptoms for the driver
Na co może wpływać usterka2
- The module switches its communication off (bus-off)
- It stays off until the power supply is cut
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.