VOLVO
BCM-B10DF46 - Master cylinder isolation valve. System Internal Failures. Calibration / parameter memory failure
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
13 modeliC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V50 (2004–2013), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (14)
- Volvo C30 (2007–2013)2011–2013Tylko silnik: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Tylko silnik: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Wszystkie silniki oprócz: B5254T7
- Volvo S40 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo S60 (2011–)2011–2015
- Volvo S80 (2007–)2007–2015
- Volvo V40 (2013–)2013–2015
- Volvo V40 Cross Country (2013–)2013–2015
- Volvo V50 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo V60 (2011–)2011–2015
- Volvo V60 Cross Country (2015–)2015
- Volvo V70 (2008–)2008–2015
- Volvo XC60 (2009–)2009–2015
- Volvo XC70 (2008–)2008–2015
Co oznacza ten kod błędu?
The brake control module is delivered calibrated from the factory and checks at start-up that its calibration data is correct. The code is set when the module lacks calibration data or when calibration has not been carried out. The fault may remain after a module has been replaced until it has been calibrated.
Możliwe przyczyny
- The fitted brake control module lacks calibration data
- Calibration of the brake control module has not been carried out
- Damaged brake control module
Co możesz zrobić
- 1Clear the codes in the brake control module and check whether the code returns
- 2If the code returns, a workshop should replace the brake control module
- 3After fitting, the acceleration sensor and the internal sensors of the brake control module must be calibrated; have a workshop do this
- 4The brake system is safety critical: do not work on the brake control module or its calibration yourself, and have a workshop repair the fault
Objawy, które możesz zauważyć5
- Information lamp on
- Anti-spin does not work
- ABS does not work or switches on suddenly
- Hill start assist does not work
- Forward monitoring and adaptive cruise control do not work
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.