VOLVO
BCM-C003A01 - Right Rear Wheel Speed Sensor. General Failure Information. General electrical failure
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
8 modeliS60 (2011–), S80 (2007–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (12)
- Volvo S60 (2011–)2011–2015
- Volvo S80 (2007–)2007–2015
- Volvo V60 (2011–)2011–2015
- Volvo V60 Cross Country (2015–)2015
- Volvo V70 (2008–)2008–2015
- Volvo XC60 (2009–)2009–2015
- Volvo XC70 (2008–)2008–2015
- Volvo XC90 (2003–)2005–2006Tylko silnik: B8444S
- Volvo XC90 (2003–)2007–2010Tylko silnik: B6324S, B8444S
- Volvo XC90 (2003–)2011Tylko silnik: B6324S5, B8444S
- Volvo XC90 (2003–)2012Tylko silnik: B6324S5
- Volvo XC90 (2003–)2013–2014Wszystkie silniki oprócz: B5254T9
Co oznacza ten kod błędu?
The brake control module (BCM) has registered that the signal from the wheel sensor at the right rear wheel is disturbed or interrupted many times. The sensor reads the wheel speed from a tone wheel, and ABS and several stability functions use this information. The fault is electrical and most often lies in the wiring or connectors, but the sensor or an internal disturbance in the module can also be the cause.
Możliwe przyczyny
- Poor contact in the connections
- Open or short circuit in the supply wire to the wheel sensor
- Open or short circuit to ground or supply voltage in the signal wire
- Damaged wheel speed sensor
- Internal fault in the brake control module
Co możesz zrobić
- 1Read and note the code, clear it and road test the car to see whether it returns
- 2Check that the connectors at the wheel sensor and at the brake control module are secure and free from oxidation
- 3Follow the cable from the sensor into the wheel arch and check for breaks, chafing and short circuits to ground or supply voltage
- 4Read the wheel speed with diagnostic equipment, as a good contact shows the value updating
- 5Replace the sensor or repair the wiring as needed, then clear the code
- 6The braking system is safety critical: do not work on the ABS system or the wheel sensor yourself; leave this to a workshop, and drive carefully until the fault is fixed
Objawy, które możesz zauważyć5
- General warning lamp and ABS warning lamp on
- ABS, anti-spin and stability function do not work
- Adaptive cruise control and collision warning do not work
- Cruise control will not engage
- Front monitoring and City Safety do not work
Na co może wpływać usterka2
- ABS, traction control, stability control and brake assistance are blocked
- Active yaw control (AYC) is blocked
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.