VOLVO
BCM-C003A15 - Right Rear Wheel Speed Sensor. General Electrical Failures. Circuit short to battery or open
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
6 modeliC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V40 (2013–), V40 Cross Country (2013–), V50 (2004–2013)
Pokaż modele wg rocznika i silnika (7)
- Volvo C30 (2007–2013)2011–2013Tylko silnik: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Tylko silnik: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Wszystkie silniki oprócz: B5254T7
- Volvo S40 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo V40 (2013–)2013–2015
- Volvo V40 Cross Country (2013–)2013–2015
- Volvo V50 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
Co oznacza ten kod błędu?
The brake control module (BCM) has detected a short to battery voltage or an open circuit in the circuit to the wheel speed sensor at the right rear wheel. The sensor is needed for ABS and several stability functions, so these are affected when the signal is missing. The fault most often lies in the wiring, a connector or the sensor.
Możliwe przyczyny
- Contact resistance in the connections
- Open circuit in the supply or signal wire
- Supply wire shorted to ground
- Wires shorted to each other
- Damaged wheel speed sensor
Co możesz zrobić
- 1Check that the fuses are intact; their locations are in the owner's manual or on the fuse box cover
- 2Read and note the code, clear it and road test the car to see whether it returns
- 3Check the connector at the wheel sensor and at the brake control module for oxidation and contact resistance
- 4Follow the cable from the sensor into the wheel arch and check for breaks, chafing and a short to battery voltage or ground
- 5Check the signal with diagnostic equipment and replace the sensor or wiring as needed
- 6The braking system is safety critical: do not work on the wheel sensor or braking system yourself; leave this to a workshop
Objawy, które możesz zauważyć5
- ABS warning lamp and brake system warning lamp on
- Traction control warning lamp on
- Traction control does not work
- Stability function does not work
- Anti-spin function does not work
Na co może wpływać usterka2
- ABS, traction control, stability control and brake assistance can be disabled
- Active yaw control (AYC) is blocked
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.