VOLVO
BCM-C004449 - Brake Pressure Sensor "A". System Internal Failures. Internal electronic failure
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
1 modelV60 (2011–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
On the V60, the brake control module (BCM) has registered an internal electrical fault in brake pressure sensor A, which measures the pressure in the braking system. The module therefore cannot rely on the pressure signal, and several stability and brake assist functions may be switched off.
Możliwe przyczyny
- Damaged pressure sensor
- Internal fault in the brake control module
Co możesz zrobić
- 1Read and note the code, clear it and road test the car to see whether it returns
- 2Check that brake pressure rises when the pedal is pressed, which a workshop can read with diagnostic equipment
- 3If the code returns, the brake control module normally needs replacing by a workshop, and the acceleration sensor and internal sensors must then be calibrated afterwards
- 4The braking system is safety critical: do not work on the brake system yourself; leave this to a workshop, and drive carefully until the fault is fixed
Objawy, które możesz zauważyć5
- Front monitoring and City Safety do not work
- Cruise control will not engage
- Anti-spin function does not work
- Brake pedal requires more force than normal
- Parking brake has reduced or incorrect function
Na co może wpływać usterka2
- Active yaw control (AYC) is blocked
- Traction control, stability control and brake assistance can be disabled
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.