VOLVO
BCM-C005154 - Steering Wheel Position Sensor. System Programming Failures. Missing calibration
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
2 modeleV40 (2013–), V40 Cross Country (2013–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
On the V40, the brake control module (BCM) has found that the checksum of the stored calibration values for the stability system sensors does not match. The calibration has not been carried out, or has been reset, so the stability functions are blocked until it is done.
Możliwe przyczyny
- Calibration of the steering angle sensor has not been carried out
- The code may have been set after the offset values of the acceleration sensors were reset
- Damaged brake control module
Co możesz zrobić
- 1Read and note the code. If it was only stored during a software update, it can be cleared
- 2Have a workshop carry out the calibration of the steering angle sensor and the stability sensors with diagnostic equipment
- 3Clear the code only after calibration, then road test the car to see whether it returns
- 4If the fault remains after calibration, the brake control module needs checking by a workshop
- 5The braking system and steering are safety critical: do not work on the calibration or the sensors yourself; leave this to a workshop
Objawy, które możesz zauważyć3
- Yellow warning symbol and message in the display
- Anti-spin function does not work
- Stability function does not work
Na co może wpływać usterka3
- Traction control is blocked
- Stability control is blocked
- Active yaw control (AYC) is blocked
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.