VOLVO
BCM-C006154 - Lateral Acceleration Sensor. System Programming Failures. Missing calibration
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
6 modeliC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V40 (2013–), V40 Cross Country (2013–), V50 (2004–2013)
Pokaż modele wg rocznika i silnika (7)
- Volvo C30 (2007–2013)2011–2013Tylko silnik: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Tylko silnik: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Wszystkie silniki oprócz: B5254T7
- Volvo S40 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo V40 (2013–)2013–2015
- Volvo V40 Cross Country (2013–)2013–2015
- Volvo V50 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
Co oznacza ten kod błędu?
On cars with DSTC, the brake control module (BCM) has found that the calibration of the stability sensor is missing or has been reset. The code may be set after the stored offset values have been cleared, for example during a software update, and then it only needs clearing.
Możliwe przyczyny
- The code may be set after the offset values for the sensors in the stability sensor have been reset
- Damaged brake control module
Co możesz zrobić
- 1If the code was stored during a software update, clearing it is enough. Then road test the car to see whether it returns
- 2Have a workshop calibrate the brake control module following the manufacturer's instructions with diagnostic equipment, then clear the code
- 3After calibration, read the code status; if it now shows as intermittent, the fault is no longer present
- 4If the code returns after calibration, the brake control module normally needs replacing by a workshop
- 5The braking system is safety critical: do not carry out the calibration yourself; leave this to a workshop, and drive carefully until the fault is fixed
Objawy, które możesz zauważyć5
- Information lamp lit
- Traction control does not work
- Stability function does not work
- Anti-spin function does not work
- Yellow warning symbol and message in the display
Na co może wpływać usterka3
- Traction control is blocked
- Stability control is blocked
- Active yaw control (AYC) is blocked
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.