VOLVO
BCM-C006254 - Longitudinal Acceleration Sensor. System Programming Failures. Missing calibration
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
2 modeleV40 (2013–), V40 Cross Country (2013–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
On the V40, the longitudinal acceleration sensor, which is part of the acceleration sensor (IMU), has not been calibrated. The code is often set after the brake control module or the airbag control module has been replaced, and the stability functions are then blocked until calibration is done.
Możliwe przyczyny
- Brake control module replaced
- Airbag control module replaced
Co możesz zrobić
- 1If the airbag control module has been replaced, the acceleration sensor must be calibrated first, and then the brake control module
- 2If only the brake control module has been replaced, it is enough to calibrate that module
- 3After calibration, read the code status and road test the car to check that the fault is fixed
- 4The braking system and airbags are safety critical: do not work on the calibration yourself; leave this to a workshop
Objawy, które możesz zauważyć1
- Anti-spin and anti-skid indication shows a fault or no indication
Na co może wpływać usterka3
- Traction control is blocked
- Stability control is blocked
- Active yaw control (AYC) is blocked
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.