VOLVO
BCM-C006428 - Roll Rate Sensor. General Signal Failures. Signal bias level out of range / zero adjustment failure
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
13 modeliC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V50 (2004–2013), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (14)
- Volvo C30 (2007–2013)2011–2013Tylko silnik: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Tylko silnik: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Wszystkie silniki oprócz: B5254T7
- Volvo S40 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo S60 (2011–)2011–2015
- Volvo S80 (2007–)2009–2015
- Volvo V40 (2013–)2013–2015
- Volvo V40 Cross Country (2013–)2013–2015
- Volvo V50 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo V60 (2011–)2011–2015
- Volvo V60 Cross Country (2015–)2015
- Volvo V70 (2008–)2009–2015
- Volvo XC60 (2009–)2009–2015
- Volvo XC70 (2008–)2009–2015
Co oznacza ten kod błędu?
The stability sensor has a correction value for its individual deviation in roll motion, and the value has been judged unreasonable. The fault often lies in how the sensor is mounted or in a missing calibration, not in the brake control module.
Możliwe przyczyny
- Stability sensor incorrectly fitted
- Loose stability sensor
- Bent bracket for the stability sensor
- Internal fault in the stability sensor
- Brake control module calibration missing
Co możesz zrobić
- 1Read and note the code, clear it and road test the car to see whether it returns
- 2Check that the stability sensor is secure and correctly fitted to the bracket under the passenger seat, and that the bracket is not bent
- 3Have a workshop calibrate the brake control module and check the sensor with diagnostic equipment. Read the code status without switching the ignition off after the road test
- 4If the fault remains, the stability sensor needs replacing by a workshop, and calibration must be done afterwards
- 5The braking system is safety critical: do not work on the stability sensor or braking system yourself; leave this to a workshop
Objawy, które możesz zauważyć5
- Anti-spin function does not work
- Front monitoring and active safety do not work
- Brake pedal requires more force than normal
- Cruise control will not engage
- Stability function does not work
Na co może wpływać usterka3
- Traction control and stability control can be disabled
- Active yaw control (AYC) is blocked
- Roll control (RSC) is blocked
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.