VOLVO
BCM-C006A01 - Multi-axis Acceleration Sensor. General Failure Information. General electrical failure
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
9 modeliC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S80 (2007–), V50 (2004–2013), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (14)
- Volvo C30 (2007–2013)2011–2013Tylko silnik: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Tylko silnik: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Wszystkie silniki oprócz: B5254T7
- Volvo S40 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo S80 (2007–)2007–2015
- Volvo V50 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo V70 (2008–)2008–2015
- Volvo XC60 (2009–)2009–2012
- Volvo XC70 (2008–)2008–2015
- Volvo XC90 (2003–)2005–2006Tylko silnik: B8444S
- Volvo XC90 (2003–)2007–2010Tylko silnik: B6324S, B8444S
- Volvo XC90 (2003–)2011Tylko silnik: B6324S5, B8444S
- Volvo XC90 (2003–)2012Tylko silnik: B6324S5
- Volvo XC90 (2003–)2013–2014Wszystkie silniki oprócz: B5254T9
Co oznacza ten kod błędu?
On cars with DSTC, the brake control module (BCM) supplies the stability sensor with voltage when the ignition is switched on. If the supply voltage to the AYC sensor falls outside the permitted range, even though the module has not energised it, the code is set.
Możliwe przyczyny
- Contact resistance or oxidation in connectors and joints
- Wires to the AYC sensor's supply shorted to ground or supply voltage
- Break in the wire to the AYC sensor's supply
- Internal fault in the AYC sensor
Co możesz zrobić
- 1Read and note the code, clear it and road test the car. If the code is intermittent, poor contact is the likely cause
- 2Check the connectors at the brake control module and the AYC sensor for contact resistance and oxidation
- 3Check the supply wire to the sensor for a short to ground or supply voltage, and for breaks
- 4Read the supply voltage with diagnostic equipment and replace the sensor if the supply is in order
- 5The braking system is safety critical: do not work on the sensor or braking system yourself; leave this to a workshop
Objawy, które możesz zauważyć5
- General warning lamp on
- Anti-spin function does not work
- Stability function does not work
- Anti-skid function does not work
- Adaptive cruise control and collision warning do not work
Na co może wpływać usterka1
- Traction control, stability control and dynamic stability control (AYC) are blocked
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.