VOLVO
BCM-C100064 - Hill Descent Control (HDC) Function. Algorithm Based Failures. Signal plausibility failure
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
11 modeliC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2011–), V40 (2013–), V40 Cross Country (2013–), V50 (2004–2013), V60 (2011–), V60 Cross Country (2015–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (14)
- Volvo C30 (2007–2013)2011–2013Tylko silnik: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Tylko silnik: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Wszystkie silniki oprócz: B5254T7
- Volvo S40 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo S60 (2011–)2011–2015
- Volvo V40 (2013–)2013–2015
- Volvo V40 Cross Country (2013–)2013–2015
- Volvo V50 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo V60 (2011–)2011–2012
- Volvo V60 (2011–)2013–2014Wszystkie silniki oprócz: D82PHEV
- Volvo V60 (2011–)2015Wszystkie silniki oprócz: D82PHEV, D87PHEV
- Volvo V60 Cross Country (2015–)2015
- Volvo XC60 (2009–)2009–2015
- Volvo XC70 (2008–)2008–2015
Co oznacza ten kod błędu?
The hill descent control (HDC) uses gear information that the brake control module (BCM) receives over the car's data network. When the gear information calculated by the module does not match what has been sent over the network, the code is set and the function is blocked.
Możliwe przyczyny
- Interference or temporary breaks on the CAN network
- Contact resistance or oxidation in connectors and joints
- Faulty reverse light switch
- Faulty first gear switch connector
- Fault in the central electronic module
Co możesz zrobić
- 1Read the codes in the central electronic module and the engine management first, as the fault often starts there
- 2Check the reverse light switch and the first gear switch connector for contact resistance and oxidation
- 3Check that the reverse lights come on when reverse is selected and go off when you change gear
- 4Road test the car and check that the function works again when you drive in first gear and then reverse
- 5The braking system is safety critical: do not work on the brake control module or the data network yourself; leave this to a workshop
Objawy, które możesz zauważyć1
- Hill descent assist does not work
Na co może wpływać usterka1
- Hill descent control (HDC) is blocked
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.