VOLVO
BCM-C102B00 - ABS Secondary Circuit Pressure lower than Primary. General Failure Information. No sub type information
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
1 modelV60 (2011–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The brake control module (BCM) compares the pressure in the primary and secondary brake circuits. The code appears when the backup brake circuit reads less pressure than the main circuit, which suggests a leak or damage in the hydraulics. The check is run when the ignition is switched on.
Możliwe przyczyny
- Leak in the brake hydraulic system
- Damage to the hydraulic system, for example a brake line
- Damaged pressure sensor
Co możesz zrobić
- 1Check whether brake fluid is visible under the car or the level in the reservoir has dropped, and look for leaks
- 2Check that the brake lines and connections to the brake control module are undamaged and secure
- 3Repair any leaks or damage and clear the code
- 4If the fault returns, have a workshop check or replace the brake control module and recalibrate the sensors
- 5The brake system is safety-critical, so have a workshop carry out all work on the hydraulics and the control module
Objawy, które możesz zauważyć3
- Hill start assist does not work
- Traction control does not work
- ABS does not work or switches on suddenly
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.