VOLVO
BCM-C107968 - Indirect Tire Pressure Monitoring System. Algorithm Based Failures. Event information
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
8 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Co oznacza ten kod błędu?
The brake control module (BCM) has not been able to complete the calibration of the indirect tyre pressure monitoring during normal driving. The system needs a certain driving pattern to calculate tyre pressure, and the code shows that the calibration is not finished. It is not a physical fault in the module.
Możliwe przyczyny
- The car has been driven on poor roads
- The car has been driven in a way that is not normal driving, for example with hard manoeuvres
Co możesz zrobić
- 1Drive the car normally on an even road with good surface for a while so the system has time to calibrate
- 2Check that the tyre pressure is correct and that all tyres are the same type and size
- 3Clear the code and check whether it returns after a few normal drives
- 4If the fault remains, have a workshop check the calibration with diagnostic equipment
- 5The brake system is safety-critical, so do not replace the brake control module for this code; leave the assessment to a workshop
Objawy, które możesz zauważyć2
- The tyre pressure monitoring indication is missing or shows a fault
- Yellow warning symbol and text message in the display
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.