VOLVO
BCM-C110768 - Communication between control modules. Algorithm error. Event-controlled information
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
1 modelXC90 (2003–)
Co oznacza ten kod błędu?
The brake control module (BCM) is waiting for the steering angle sensor to be initialised, which happens when the steering wheel is turned a little after start-up. If initialisation has not taken place after a longer distance at a sufficient speed, the code is set, and stability control stays switched off until the sensor is initialised.
Możliwe przyczyny
- The steering angle sensor has not been initialised after a longer distance
- The steering wheel has not been turned after the car was started
Co możesz zrobić
- 1Drive a short distance and turn the steering wheel a little in both directions so the steering angle sensor initialises
- 2Check whether the traction control warning lamp goes out once the sensor has been initialised
- 3If this code is stored on its own it can be cleared once the steering angle sensor is initialised
- 4If a steering angle sensor code is also present, have a workshop diagnose it with diagnostic equipment
- 5The brake and stability systems are safety-critical, so have a workshop carry out any work on the module
Objawy, które możesz zauważyć2
- General warning lamp on
- Anti-skid function does not work
Na co może wpływać usterka1
- Dynamic stability control (AYC) is disabled
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.