VOLVO
BCM-C11081C - Pedal Sensor(s) Supply Voltage. General Electrical Failures. Circuit voltage out of range
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
1 modelV60 (2011–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The brake control module (BCM) has registered that the voltage to the brake pressure and pedal position sensors is wrong, and that the fault is caused by a wire shorted to supply voltage or to ground. The stability systems are then switched off. The fault can only be detected once the test has started and the conditions are met.
Możliwe przyczyny
- Wire shorted to supply voltage
- Wire shorted to ground
Co możesz zrobić
- 1Check that the fuses are intact; their locations are in the owner's manual or on the fuse box cover
- 2Where possible, check that the relevant functions work using the switches, controls and a road test
- 3Check the wiring to the sensors for chafing and short circuits
- 4Read the codes with diagnostic equipment and correct the fault in the circuit before replacing any component
- 5The brake system is safety-critical, so avoid driving with reduced braking function and have a workshop repair the fault
Objawy, które możesz zauważyć3
- Traction control and anti-skid warning lamps show a fault
- Traction control does not work
- Stability function does not work
Na co może wpływać usterka2
- Traction control and stability control are switched off
- Dynamic stability control (AYC) is disabled
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.