VOLVO
BCM-C113564 - Left Rear Brake Pressure Sensor. Algorithm Based Failures. Signal plausibility failure
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
1 modelV60 (2011–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The two signals from the brake pressure sensor at the rear left wheel do not agree with each other. The pressure measured in one signal differs from the combined pressure and temperature signal. This indicates that the sensor or the brake control module is faulty.
Możliwe przyczyny
- Damaged rear left brake pressure sensor
- Internal fault in the brake control module
Co możesz zrobić
- 1Switch the ignition off and have a workshop with diagnostic equipment establish which part is at fault
- 2Replace the brake control module if the fault remains, bearing in mind that the new one must be calibrated
- 3After the replacement the internal sensors must be calibrated, as the acceleration sensor (IMU) also needs it
- 4Switch the ignition on again and choose to continue the calibration when the system asks
- 5The brake system is safety-critical, so have a workshop carry out all work on the sensor and the module
Objawy, które możesz zauważyć4
- Hill descent assist does not work
- Front monitoring and adaptive cruise control do not work
- Hill start assist does not work
- Traction control does not work
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.