VOLVO
BCM-U002855 - Vehicle Communication Bus A. System Programming Failures. Not configured
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
6 modeliS60 (2011–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), XC60 (2009–)
Co oznacza ten kod błędu?
The brake control module (BCM) and the main unit of the airbag system (SRS) use a configuration ID to work together on the local sensor network. The code is set when the BCM's ID does not match the one the SRS sends out. This most often happens when a module has been replaced without the correct software being downloaded.
Możliwe przyczyny
- Incorrect configuration ID, for example a used module with software or hardware not intended for the car
Co możesz zrobić
- 1Ask whether any module has been replaced, and whether the correct software was downloaded at the time
- 2Download new software to the brake control module or to the front monitoring module following the workshop procedure, then check that the code is not set again
- 3If the fault remains after reprogramming, troubleshoot the wiring of the local sensor network between the front monitoring module and the airbag system
- 4The airbag and brake systems are safety-critical, so do not work on them yourself and have a workshop carry out all programming
Objawy, które możesz zauważyć5
- Traction control warning lamp lit
- Stability function does not work
- Traction control does not work
- Anti-skid function does not work
- Adaptive cruise control and collision and brake support do not work
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.