VOLVO
BCM-U010100 - Lost communication with Transmission Control Module (TCM). General Failure Information. No sub type information
Układ
Sterownik układu hamulcowego (BCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
7 modeliC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V40 (2013–), V40 Cross Country (2013–), V50 (2004–2013), V60 (2011–)
Pokaż modele wg rocznika i silnika (9)
- Volvo C30 (2007–2013)2011–2013Tylko silnik: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Tylko silnik: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Wszystkie silniki oprócz: B5254T7
- Volvo S40 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo V40 (2013–)2013–2015
- Volvo V40 Cross Country (2013–)2013–2015
- Volvo V50 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo V60 (2011–)2013–2014Tylko silnik: D82PHEV
- Volvo V60 (2011–)2015Tylko silnik: D82PHEV, D87PHEV
Co oznacza ten kod błędu?
The brake control module (BCM) cannot make contact with the transmission control module (TCM) on the CAN network, or the communication is disturbed. The stability functions then cannot receive information about the gearbox. The fault most often comes from interference or intermittent breaks on the network rather than from an internal fault in the brake control module.
Możliwe przyczyny
- Interference or intermittent breaks on the CAN network
- Fault in the transmission control module (TCM)
Co możesz zrobić
- 1Read codes in the central electronic module and any other affected modules first, and correct them before this code is cleared
- 2If no codes are stored, check the CAN wiring between the brake control module and the transmission control module for breaks and shorts
- 3Check that the wiring is not routed too close to sources of interference, such as mobile phones
- 4Clear the code only once the other codes are corrected, and check that it does not return after a road test
- 5The brake system is safety-critical, so have a workshop carry out any work on the wiring and the modules
Objawy, które możesz zauważyć4
- Traction control warning lamp lit
- Stability function does not work
- Traction control does not work
- Anti-skid function does not work
Na co może wpływać usterka3
- Stability control is disabled
- Traction control is disabled
- Dynamic stability control (AYC) is disabled
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.