Co oznacza kod błędu CCM-00A1?

Diagnostyka i definicja kodu błędu dla CCM-00A1 (Volvo S60 (2001–2009), Volvo S80 (1999–2006), Volvo V70 (2000–2008)). Zamów naprawę w OBD Tuning.

VOLVO

CCM-00A1 - Blower fan motor. Signal too high

Układ

Sterownik klimatyzacji (CCM)

Modele Volvo, których dotyczy ten kod błędu

Dotyczy następujących modeli:

5 modeli

S60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)

Pokaż modele wg rocznika i silnika (5)

Co oznacza ten kod błędu?

The climate control module (CCM) monitors a signal from the blower fan motor and has registered that it is too high. This can mean the fan is blocked, or that the signal is faulty somewhere on the way between the fan motor and the control module. While the fault remains the fan will not start, and the cooling from the A/C system is lost.

Możliwe przyczyny

Blocked blower fan motor
Open circuit in the signal wire or the ground wire to the fan motor
Control signal wire shorted to ground or battery voltage
Diagnostic signal wire shorted to battery voltage
Defective blower fan motor or power unit
Contact resistance

Co możesz zrobić

1With the ignition on, turn the fan control to highest, then lowest speed, and check the fan runs smoothly. If the battery was disconnected, a workshop may need to recalibrate it
2Check that the connectors at the fan motor and the climate control module are firmly seated. If any is loose, push it fully home and see whether the fan works
3Check that nothing is blocking the fan wheel in the climate system and that it turns freely by hand
4Check the fuses and the earth points to the fan motor, and use a multimeter to confirm that the ground wire is intact and has contact with ground (the body)
5Check that the signal and control wires have no chafing or broken insulation
6If the fault remains after these checks, have a workshop check the fan motor and power unit

Objawy, które możesz zauważyć3

The blower fan does not work
Airflow problem
No cooling from the A/C system

Na co może wpływać usterka2

While the fault remains, the control module does not release the fan motor
The A/C compressor cannot start

Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.