VOLVO
CEM-5A61 - PTC heater. Faulty signal
Układ
Centralny moduł elektroniczny (CEM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
4 modeleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Pokaż modele wg rocznika i silnika (19)
- Volvo C30 (2007–2013)2007–2009Tylko silnik: B4184S11, B4184S8, B4204S3, D4164T, D4204T
- Volvo C30 (2007–2013)2010Tylko silnik: B4184S11, B4184S8, B4204S3, B4204S4, D4164T, D4204T
- Volvo C30 (2007–2013)2011Tylko silnik: B4204S3, B4204S4, D4162T, D4164T
- Volvo C30 (2007–2013)2012–2013Tylko silnik: B4204S3, B4204S4, D4162T
- Volvo C70 (2006–2013)2008–2010Tylko silnik: D4204T
- Volvo S40 (2004–2013)2004Tylko silnik: D4204T, D4204T2
- Volvo S40 (2004–2013)2005Tylko silnik: B4184S11, D4164T, D4204T, D4204T2
- Volvo S40 (2004–2013)2006Tylko silnik: B4184S11, B4184S8, D4164T, D4204T, D4204T2
- Volvo S40 (2004–2013)2007–2009Tylko silnik: B4184S11, B4184S8, B4204S3, D4164T, D4204T
- Volvo S40 (2004–2013)2010Tylko silnik: B4184S11, B4184S8, B4204S3, B4204S4, D4164T, D4204T
- Volvo S40 (2004–2013)2011Tylko silnik: B4204S3, B4204S4, D4162T, D4164T
- Volvo S40 (2004–2013)2012Tylko silnik: B4204S3, B4204S4, D4162T
- Volvo V50 (2004–2013)2004Tylko silnik: D4204T, D4204T2
- Volvo V50 (2004–2013)2005Tylko silnik: B4184S11, D4164T, D4204T, D4204T2
- Volvo V50 (2004–2013)2006Tylko silnik: B4184S11, B4184S8, D4164T, D4204T, D4204T2
- Volvo V50 (2004–2013)2007–2009Tylko silnik: B4184S11, B4184S8, B4204S3, D4164T, D4204T
- Volvo V50 (2004–2013)2010Tylko silnik: B4184S11, B4184S8, B4204S3, B4204S4, D4164T, D4204T
- Volvo V50 (2004–2013)2011Tylko silnik: B4204S3, B4204S4, D4162T, D4164T
- Volvo V50 (2004–2013)2012Tylko silnik: B4204S3, B4204S4, D4162T
Co oznacza ten kod błędu?
The central electronic module (CEM) controls the power to the electrical additional heater through an output, and the fault code is stored when the signal on that output is faulty. It shows as poor heating in the passenger compartment, because the additional heater does not work as it should.
Możliwe przyczyny
- Signal cable to the additional heater short-circuited to ground
- Faulty signal from the CEM output
Co możesz zrobić
- 1Switch the ignition on, activate the electrical additional heater and check whether it gets warm
- 2If it does not warm up, the fault is probably permanent; if it warms up, the fault was present earlier but is not active now
- 3Check the control signal cable for chafing and pinching
- 4Use a multimeter to check that the control cable to the additional heater has no contact with ground (the body)
- 5Remedy what is found and check that the cabin heating improves
Objawy, które możesz zauważyć1
- Poor heating in the passenger compartment
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.