Przejdź do treści
    OBD Tuning
    WYŚLIJ DO NAS
    WYŚLIJ DO NAS
    Strona główna
    Kody błędów
    VOLVO
    CEM-8A38
    VOLVO

    CEM-8A38 - Gas discharge lamp module (GDL) right-hand. Faulty signal

    Układ

    Centralny moduł elektroniczny (CEM)

    Modele Volvo, których dotyczy ten kod błędu

    Dotyczy następujących modeli:

    4 modele

    C30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)

    Pokaż modele wg rocznika i silnika (4)
    • Volvo C30 (2007–2013)2007–2011
    • Volvo C70 (2006–2013)2006–2011
    • Volvo S40 (2004–2013)2004–2007
    • Volvo V50 (2004–2013)2004–2007

    Co oznacza ten kod błędu?

    The right-hand gas discharge lamp module (GDL) reports a fault in the signal from the actuator motor in the right headlamp. The code points to an open circuit or a short circuit in the signal wire. The high beam does not work, and only the low beam remains.

    Możliwe przyczyny

    • Open circuit in the signal wire to the right-hand actuator motor
    • The signal wire to the right-hand actuator motor is short-circuited to battery voltage
    • The signal wire to the right-hand actuator motor is short-circuited to ground

    Co możesz zrobić

    1. 1Activate the high beam with the ignition on. If it stays dark the fault is likely permanent; if it lights but the code was stored earlier, it is intermittent
    2. 2Switch the ignition off and check that the connectors at the right headlamp are clean, firmly fitted and undamaged
    3. 3Use a multimeter to check that the signal wire between the right headlamp and the module is not broken and has no contact with ground or voltage
    4. 4If the fault remains, have a workshop replace the right lamp housing and check the signal wires

    Objawy, które możesz zauważyć1

    • The high beam does not work

    Na co może wpływać usterka1

    • Only the low beam works

    Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.

    OBD Tuning

    Wiodące centrum ekspertów Szwecji w elektronice motoryzacyjnej. Oferujemy profesjonalną optymalizację silnika, naprawę sterowników i diagnostykę z gwarancją 12 miesięcy.

    Usługi

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    Baza danych & Diagnostyka

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    Producenci ECU

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Firma

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    Odwiedź nas

    Gjuterigatan 29, Karlstad

    Zadzwoń do nas

    054-830 480

    Napisz do nas

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Wszelkie prawa zastrzeżone.