Przejdź do treści
    OBD Tuning
    WYŚLIJ DO NAS
    WYŚLIJ DO NAS
    Strona główna
    Kody błędów
    VOLVO
    CEM-8F2D
    VOLVO

    CEM-8F2D - Wipers. Signal too low. Intermittent fault

    Układ

    Centralny moduł elektroniczny (CEM)

    Modele Volvo, których dotyczy ten kod błędu

    Ten kod błędu ma różne znaczenie w zależności od modelu, rocznika lub silnika. Wybierz znaczenie, które dotyczy Twojego samochodu.

    Dotyczy następujących modeli:

    5 modeli

    S60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)

    Pokaż modele wg rocznika i silnika (5)
    • Volvo S60 (2001–2009)2001–2004
    • Volvo S80 (1999–2006)1999–2004
    • Volvo V70 (2000–2008)2000–2004
    • Volvo V70 XC / XC70 (2001–2007)2001–2004
    • Volvo XC90 (2003–)2003–2004

    Co oznacza ten kod błędu?

    The fault is intermittent: on an earlier occasion the CEM registered that the wiper stayed somewhere on the glass too long, while the steering wheel module (SWM) had not asked for it to run. It is no longer present, but the cause may be a signal wire shorted to ground, or a damaged wiper motor.

    Możliwe przyczyny

    • Signal wire between the CEM and the rain sensor shorted to ground
    • Signal wire from the wiper motor position sensor to the CEM shorted to ground
    • Damaged windscreen wiper motor
    • Signal wire to the rain sensor may be pinched under the base of the interior mirror

    Co możesz zrobić

    1. 1Clear the code and check whether it returns; an intermittent fault can be a temporary disturbance
    2. 2Check that the wipers have not stuck on the glass
    3. 3Look for an intermittent short to ground in the signal wires to the rain sensor and the wiper motor position sensor
    4. 4Check that the connectors are firmly seated and clean
    5. 5If the fault returns, have a workshop check the wiring and replace the wiper motor if needed

    Objawy, które możesz zauważyć2

    • The wiper motor does not work, and the wiper may have stuck on the glass
    • The rain sensor does not work

    Na co może wpływać usterka2

    • The wipers run at low speed for a while and then stop anywhere on the glass
    • After several repeats the wipers stand still for a while before the cycle starts again

    Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.

    OBD Tuning

    Wiodące centrum ekspertów Szwecji w elektronice motoryzacyjnej. Oferujemy profesjonalną optymalizację silnika, naprawę sterowników i diagnostykę z gwarancją 12 miesięcy.

    Usługi

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    Baza danych & Diagnostyka

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    Producenci ECU

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Firma

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    Odwiedź nas

    Gjuterigatan 29, Karlstad

    Zadzwoń do nas

    054-830 480

    Napisz do nas

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Wszelkie prawa zastrzeżone.