VOLVO
CEM-B10E712 - Relay 15-feed. General Electrical Failures. Circuit short to battery
Układ
Centralny moduł elektroniczny (CEM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
9 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Co oznacza ten kod błędu?
The 15 feed is the supply that follows the ignition, and the CEM controls the output signal to its relay. The code is stored when the output to the relay coil has contact with supply voltage. The engine may then have difficulty starting or not start at all, and the fault shows up sometimes or always.
Możliwe przyczyny
- The cable has contact with supply voltage
- The relay for the 15 feed in the engine compartment relay and fuse box is damaged
Co możesz zrobić
- 1Check that the relevant fuses are intact. Their locations are in the owner's manual or on the fuse box cover
- 2Check that the relay for the 15 feed is seated firmly in the relay and fuse box and is not corroded
- 3Look for chafing on the cable to the relay
- 4Use a multimeter to check whether the cable to the relay coil has voltage when the ignition is off
- 5If the fault remains after these checks, have a workshop with diagnostic equipment check the relay and the wiring
Objawy, które możesz zauważyć2
- Engine fails to start
- Engine does not start, either sometimes or always
Na co może wpływać usterka3
- The output switches off in the driving cycle in which the fault is detected
- If the fault remains, the output switches off permanently after 100 driving cycles
- Clearing the fault codes resets the output
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.