CEM-B10E714
VOLVO
CEM-B10E714 - Relay 15-feed. General Electrical Failures. Circuit short to ground or open
Układ
Centralny moduł elektroniczny (CEM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
9 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Co oznacza ten kod błędu?
The CEM controls the output signal to the relay for the 15 feed. The code is stored when the output to the relay coil has an open circuit or is short-circuited to ground. The fault can cause the battery to discharge and the engine not to start.
Możliwe przyczyny
- The cable is short-circuited to ground
- Open circuit in the cable
Co możesz zrobić
- 1Check that the relevant fuses are intact. Their locations are in the owner's manual or on the fuse box cover
- 2Check the battery's charge level and that the terminal connections are tight
- 3Look for chafing and pinch damage on the cable to the 15 feed relay
- 4Use a multimeter to check that the cable to the relay coil has no contact with ground (the body)
- 5Use a multimeter to check that the cable to the relay coil has no break in it
- 6If the fault returns, have a workshop with diagnostic equipment check the relay and the wiring
Objawy, które możesz zauważyć4
- Battery discharges
- Engine does not start
- Engine does not start, either sometimes or always
- The battery is flat or has low voltage
Na co może wpływać usterka2
- The function switches off permanently after 100 driving cycles in which the fault was detected
- Clearing the fault codes resets the output
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.