Przejdź do treści
    OBD Tuning
    WYŚLIJ DO NAS
    WYŚLIJ DO NAS
    Strona główna
    Kody błędów
    VOLVO
    CEM-B113C11
    VOLVO

    CEM-B113C11 - Hazard switch illumination. General Electrical Failures. Circuit short to ground

    Układ

    Centralny moduł elektroniczny (CEM)

    Modele Volvo, których dotyczy ten kod błędu

    Dotyczy następujących modeli:

    9 modeli

    S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)

    Pokaż modele wg rocznika i silnika (9)
    • Volvo S60 (2011–)2011–2015
    • Volvo S80 (2007–)2007–2015
    • Volvo V40 (2013–)2013–2015
    • Volvo V40 Cross Country (2013–)2013–2015
    • Volvo V60 (2011–)2011–2015
    • Volvo V60 Cross Country (2015–)2015
    • Volvo V70 (2008–)2008–2015
    • Volvo XC60 (2009–)2009–2015
    • Volvo XC70 (2008–)2008–2015

    Co oznacza ten kod błędu?

    The Central Electronic Module (CEM) supplies power to the illumination in the hazard light switch. The fault is stored when the voltage from the output is too low.

    Możliwe przyczyny

    • The supply wire to the illumination is short-circuited to earth

    Co możesz zrobić

    1. 1Check that the fuses are intact
    2. 2Switch on the hazard lights and see whether the switch illumination lights, then clear the code and road test
    3. 3Check the wire from the control module to the switch for chafing, pinching and loose connectors
    4. 4Disconnect the connector at the switch and use a multimeter to check that the wire has no contact with earth (the body)
    5. 5If the fault returns, have a workshop with diagnostic equipment check the control module and the wiring

    Objawy, które możesz zauważyć2

    • Button illumination in the hazard light switch does not work
    • No clear symptoms for the driver beyond this

    Na co może wpływać usterka3

    • The output switches off during the driving cycle in which the fault is detected
    • If the fault remains, the output is switched off permanently after 100 driving cycles where the fault was detected
    • Erasing the fault codes or starting a new driving cycle resets the output

    Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.

    OBD Tuning

    Wiodące centrum ekspertów Szwecji w elektronice motoryzacyjnej. Oferujemy profesjonalną optymalizację silnika, naprawę sterowników i diagnostykę z gwarancją 12 miesięcy.

    Usługi

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    Baza danych & Diagnostyka

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    Producenci ECU

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Firma

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    Odwiedź nas

    Gjuterigatan 29, Karlstad

    Zadzwoń do nas

    054-830 480

    Napisz do nas

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Wszelkie prawa zastrzeżone.