Przejdź do treści
    OBD Tuning
    WYŚLIJ DO NAS
    WYŚLIJ DO NAS
    Strona główna
    Kody błędów
    VOLVO
    CEM-B11D914
    VOLVO

    CEM-B11D914 - Vehicle Battery. General Electrical Failures. Circuit short to ground or open

    Układ

    Centralny moduł elektroniczny (CEM)

    Modele Volvo, których dotyczy ten kod błędu

    Dotyczy następujących modeli:

    7 modeli

    S60 (2011–), S80 (2007–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)

    Pokaż modele wg rocznika i silnika (7)
    • Volvo S60 (2011–)2011–2015
    • Volvo S80 (2007–)2011–2015
    • Volvo V60 (2011–)2011–2015
    • Volvo V60 Cross Country (2015–)2015
    • Volvo V70 (2008–)2011–2015
    • Volvo XC60 (2009–)2011–2015
    • Volvo XC70 (2008–)2011–2015

    Co oznacza ten kod błędu?

    This fault code only applies to cars with automatic engine start/stop. The CEM monitors the voltage from the secondary battery, and the fault is stored when the value is wrong for too long. Common causes are poor connections, a damaged fuse, or a weak or damaged battery.

    Możliwe przyczyny

    • Contact resistance or oxidation in the connections
    • Damaged fuse for the power supply
    • Open circuit in the supply wire from the secondary battery
    • Open circuit in the earth wire of the secondary battery
    • Poorly charged battery or corroded connection cables
    • Damaged battery

    Co możesz zrobić

    1. 1Check that the battery is fully charged and is not swollen or leaking
    2. 2Check the connections to the secondary battery: corroded or loose terminals should be cleaned and tightened
    3. 3Check that the fuse for the power supply from the secondary battery is intact
    4. 4Check the earth wire from the secondary battery for breaks and loose connectors
    5. 5If the fault returns after these checks, have a workshop with diagnostic equipment check the battery and the wiring

    Objawy, które możesz zauważyć2

    • The automatic start/stop function does not work while driving
    • The automatic start/stop function does not work at idle

    Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.

    OBD Tuning

    Wiodące centrum ekspertów Szwecji w elektronice motoryzacyjnej. Oferujemy profesjonalną optymalizację silnika, naprawę sterowników i diagnostykę z gwarancją 12 miesięcy.

    Usługi

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    Baza danych & Diagnostyka

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    Producenci ECU

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Firma

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    Odwiedź nas

    Gjuterigatan 29, Karlstad

    Zadzwoń do nas

    054-830 480

    Napisz do nas

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Wszelkie prawa zastrzeżone.