VOLVO
CEM-B1D0311 - Right High Beam Circuit. General Electrical Failures. Circuit short to ground
Układ
Centralny moduł elektroniczny (CEM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
7 modeliS60 (2011–), S80 (2007–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Co oznacza ten kod błędu?
The central electronic module (CEM) feeds the right high beam from its own output. The code is set when the signal from the output is too low, which is caused by the signal cable being shorted to ground.
Możliwe przyczyny
- The signal cable to the right high beam is shorted to ground
Co możesz zrobić
- 1Read and clear the code and switch on the high beam to see whether the lamps light
- 2Check that the fuse for the high beam is intact
- 3Inspect the signal cable to the right high beam lamp for chafing and marks from heat
- 4Use a multimeter to check that the signal cable has no contact with ground (the bodywork)
- 5If the wire is intact, have a workshop with diagnostic equipment check the module output
Objawy, które możesz zauważyć2
- The right high beam does not work
- Yellow warning symbol and text message in the display
Na co może wpływać usterka3
- The function switches off during the driving cycle in which the fault is detected
- After repeated driving cycles with the fault, the function is switched off permanently
- Clearing the fault codes and starting a new driving cycle resets the output
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.