VOLVO
CEM-C1D2105 - Tire pressure sensor. General Failure Information. System Programming Failures
Układ
Centralny moduł elektroniczny (CEM)
Modele Volvo, których dotyczy ten kod błędu
Ten kod błędu ma różne znaczenie w zależności od modelu, rocznika lub silnika. Wybierz znaczenie, które dotyczy Twojego samochodu.
Dotyczy następujących modeli:
7 modeliS60 (2011–), S80 (2007–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Co oznacza ten kod błędu?
The fault code is a programming fault. It concerns a tire pressure sensor that was present in the previous drive but is not sending anything in this one. On these cars the sensor positions cannot be determined, so this has to be found with a diagnostic tool, and a new or repaired sensor needs to be activated with special equipment.
Możliwe przyczyny
- Damaged tire pressure sensor
- The remote receiver is out of action
Co możesz zrobić
- 1Check that the remote control locks and unlocks the car. If it does not, troubleshoot the remote receiver first
- 2With a diagnostic tool, see which of the four sensors has no stored ID number, since that is the likely culprit
- 3Replace the sensor that is missing, and have a workshop activate the new one with special equipment, because activation needs the tool
- 4Clear the fault code after the sensor has been activated, then drive a longer stretch at fairly high speed to see whether it returns
Objawy, które możesz zauważyć1
- A message is shown in the text display
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.